Using Pass-Though Battery:
To turn on/off click button 5 times.
You can re-charge and vape at the same time! Simply unscrew cap on bottom and connect the USB cord to continue vaping. If the battery is fully dead, try to allow 5 to 10 mins of charging before use.
Filling a Clearomizer:
The easiest to fill. First, simply remove the mouthpiece by unscrewing it. Then, be sure to hold the clearomizer at an angle while filling. Try not to drip into center tube while filling the outer tube with your eJuice. Lastly, make sure you fill to the top of line.
How to fill an Atomizer:
The 510 and 306 Atomizer are direct drip products. You must use a drip tip to vape.
Drip filling an Atomizer:
Simply drip 2-3 drops of your eJuice directly on to the atomizer. To keep the 306 atomizer wet, they are prefilled with un-flavored PG. You may have slight overflow on first fill.
There are a few different methods to fill a cartomizer. Each method has a different level of complexity and efficiency. The most popular ways are drip filling and “condom” filling.
Drip filling a Cartomizer:
Simply remove the white plug at the mouthpiece end. While holding the cartomizer at an angle, drip a few drops of eJuice into the filler material. To avoid eJuice leaking through the battery connector, try not to drip into the center tube. .
Dripping too fast when filling the cartomizer, will result in eJuice overflowing out the battery connector end of the cartomizer!
The Cap Method:
Take both covering end-caps off the of cartomizer. Use one of the end-caps from the cartomizer and place 8-10 drops of eJuice into it.
Insert the connector end of the cartomizer into the end-cap you filled with eJuice. Slowly twist and push the cartomizer down the rest of the way into the end-cap. The eJuice will absorb into the filler material.
Repeat the process as needed until the cartomizer is completely filled. This method requires a little bit of practice and it can be messier than others.
|
